High efficiency filter mesh replacement and replacement conditions

High efficiency filter mesh replacement and replacement conditions

1 When replacing the high-efficiency filter mesh, the four frames and the surrounding area where the filter mesh is installed should be wiped clean with a wet clean rag and repeated three times. The high efficiency filter should be installed immediately after wiping. High-efficiency filters should be unpacked at the site and installed immediately after inspection to prevent dust from falling into the high-efficiency filter mesh.

2 Replacement Conditions

3 The number of suspended particles in the clean room was significantly exceeded.

4 When the final air volume of the high-efficiency filter mesh falls below 70% of the initial air volume.

5 High-efficiency filter After the replacement of the mesh, the dust particle counter performs leak detection on the high-efficiency filter and the installation joint. While scanning the inspection, tighten the bolts or seal with epoxy resin.

6 The detection and replacement of high-efficiency filter meshes shall be recorded in a timely manner.

7 After a high-efficiency filter mesh replacement, a leak test shall be conducted and verified.

For more information, Bang Mai Metal Mesh Product Co., Ltd. welcome your inquiries and our company will provide you with the most professional answers.