Reverse Dutch Weave: Strength Where Pressure Is Highest
Reverse Dutch weave inverts the usual ratio, using a heavy warp and a fine weft, which produces a filter medium with an exceptionally smooth surface and high pressure resistance. Anping Ruibei Metal Mesh Factory supplies this weave as round filter screens for gas and liquid filtration, alongside its extruder screen range.
The construction is favoured where the filter must be cleaned by back-flushing rather than replaced: the flat upstream face releases the cake cleanly, and the dense warp resists deformation under differential pressure spikes.
Construction Data
| Parameter | Detail |
|---|---|
| Weave | Reverse Dutch, single layer |
| Typical materials | Stainless steel 304, 316, 316L |
| Disc diameter | Custom, punched to drawing |
| Filtration | From 10 micron upward, grade dependent |
| Edge options | Plain, spot welded rim, reinforced ring |
Where Reverse Dutch Screens Are Specified
- Polymer melt filtration at high pressure, including spin-pack and screen-changer duty.
- Hydraulic and lubricating oil circuits requiring reusable elements.
- Process gas and steam lines where stainless construction is mandatory.
- Water treatment and chemical dosing skids with back-flush cleaning.
Because the medium is metallic, it tolerates steam sterilisation, solvent wash and burning clean, which keeps total cost of ownership below disposable cartridges in many duties.
ANPING RUIBEI METAL MESH FACTORY (brand BM) is a wire mesh manufacturer and exporter established in 2015 in Anping County, Hebei, China, the country's wire mesh industry base. The factory runs 50-100 employees, exports 80%-90% of its output and reports annual sales of USD 0.8-1.3 million. Its range covers decorative wire mesh, rope mesh, metal curtain mesh, extruder screen mesh and gabion mesh, all produced under CE and CCC certification.
Buying Notes
- Minimum order 1 piece, any quantity accepted, price from USD 0.2-3.6.
- Supply ability 50,000 pieces per week; delivery 10-15 days after deposit.
- Samples free of charge; tooling for special diameters available with charge.
- Shipping by sea or express, packed in water-proof plastic film and wooden case.
Share the fluid, operating pressure and target micron rating, and Anping Ruibei will specify the weave grade and support structure that keeps differential pressure within limit.
Cleaning guidance is supplied with each batch: back-flush direction, maximum differential pressure and suitable cleaning agents. Where burning clean is used, the team advises on oven temperature and cycle count, because excessive thermal load, not the weave itself, is the usual cause of premature failure in reverse Dutch elements.
Technical documentation, including weave grade, wire diameter and micron rating, accompanies every shipment so incoming inspection can verify the element against the purchase order before it enters the filter room.